User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
150
Note
Ensure the diode polarity is correct before
performing the diode measurement.
Example
Diode measurement
DMM mode Hold on/off
Continuity Measurement
Back Ground
The continuity test checks that the resistance in
the DUT is low enough to be considered
continuous (of a conductive nature). The
continuity threshold level is set to <15Ω.
Connection
10A MAX
FUSED
V
W
COMA mA
GDS-220
Digital Storage Oscilloscope
200 MHz 1GSa/s
COM V
W
CAT II 600V
CAT III 300VFUSED
600mA MAX
Steps
1. From the multimeter settings choose the
continuity measurement.
Continuity =