User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
149
Diode Measurement
Back Ground
The diode test checks the forward bias
characteristics of a diode by running a constant
forward bias current through the DUT and
measuring the forward voltage drop.
Connection
10A MAX
FUSED
V
W
COMA mA
GDS-220
Digital Storage Oscilloscope
200 MHz 1GSa/s
COM V
W
CAT II 600V
CAT III 300VFUSED
600mA MAX
Steps
1. From the multimeter settings choose the diode
measurement.
Diode =
2. The selected mode will be previewed in the
lower corner.
Diode key
Multimeter
settings
Preview screen
3. Press anywhere outside of the multimeter
settings area to return to the main display.
4. OPEN will be displayed when the diode passes
the diode test.