User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
129
Waveform
tab
Save
button
From
3. Use the From option to select the source
waveform:
1
Channel 1
2
Channel 2
M
Math source
R1
Reference waveform 1
R2
Reference waveform 2
All Displayed
Saves all the displayed
waveforms into a directory,
ALXXXX, where XXXX is a
number that is incremented each
time a save is performed.
Destination
4. If only a single source waveform is to be saved,
the following destination options are available:
Wave1
Wave1 - Wave20
Ref
R1 - R2
File
Pressing File will allow you to
either set the file path or rename
the file from the default of
DSXXXX.LSF, where XXXXX is a
number that is incremented each
time the waveform is saved.