User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
127
Brief Mode
Brief mode adds a series of user-selectable data
to the bottom of an image file. It also reverts the
normally black background into a white
background for easy printing.
7. Toggle Brief Mode on.
8. Press Brief Mode Setting to set what data gets
saved to the image file:
Date&Time
Saves the date and time.
Vertical
Saves the vertical scale,
coupling, DC mode and
bandwidth limit of all the active
channels.
Horizontal
Saves the horizontal position
and scale.
Trigger
Saves the trigger channel,
coupling, slope, frequency
rejection, Noise rejection,
trigger level and other data
associated with the selected
trigger type.
Cursor
Saves the cursor position to the
image file.
Cursor Measure
Saves the cursor information
overlay to the image file.
Measure
Saves automatic measurements
and DMM measurement
readings.
Note
Adds a user-created note at the
bottom of the image file. Note:
Multilanguage notes are
possible if the system language
is not English.