User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
122
Running a Go-NoGo Test
Background
The Go-NoGo controls are located at the
bottom left-hand corner of the screen. The
Fail/Total ratio (Violations/Number of Tests) is
shown in the title bar.
Fail/Total ratio
Go-NoGo controls
Run Go-NoGo
Test
1. Toggle the Go-NoGo button from pause to
play.
→
The test will run continuously until the test is
stopped.
Pressing the Go-NoGo button again will stop
the test and toggle the button back to pause.
If the Violating setting was set to Stop or Stop
Beep, press the Go-NoGo button again to
restart the test after it has stopped.