User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GETTING STARTED
11
Accessories ................................................................................................................ 14
Appearance ..................................................................... 15
GDS-200/300 Front Panel ..................................................................................... 15
Rear Panel ................................................................................................................. 17
Interface Panel .......................................................................................................... 18
BNC Panel ................................................................................................................ 20
Display Overview ..................................................................................................... 21
Horizontal ................................................................................................... 21
Vertical ......................................................................................................... 22
How to Use the Touch Interface ........................................................................... 25
Help Menu ................................................................................................................ 28
Initial Setup .................................................................... 30
Power Up .................................................................................................................. 30
USB Driver Installation .......................................................................................... 31
Tilting the Stand ....................................................................................................... 32
Setting the System Date & Time ........................................................................... 33
Setting the Language ............................................................................................... 34
Switching Horizontal and Vertical View............................................................... 34
Compensating a Probe ............................................................................................ 34