User manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
103
Configure Autoset Mode
Background
There are two operating modes for the Autoset
function: Fit Screen Mode and AC Priority
Mode. Fit Screen Mode will fit the waveform to
the best scale, including any DC components
(offset). AC Priority mode will scale the
waveform to the screen by removing any DC
component.
Steps
From the Utility menu, press Autoset Mode and
select the mode.
Autoset Mode
Fit Screen Priority, AC Priority
Example 2VPP
signal with 2V DC
offset
Fit Screen
AC Priority