Software) Guide Instruction Manual

CONNECTION & CONFIGURATION

4. Configure the

1. To make sure the GDM is recognized by the PC,

open the Device Manager (Start > Control

Panel > (System) > Device Manager. The USB

driver, CP2101, should be listed in the Ports

section.

2. Check which port (COM) the USB driver is

assigned (Click on the Ports + icon).

3. To see the baud rate of the connection, right click

the CP2101 Port and select Properties.

4. Click the Port Settings tab and note the baud rate

of the connection.

5. If the PC asks for the location of the driver, point

to the driver directory (page7).

5. Configure DMM

Viewer

1. Activate DMM Viewer.