User Manual

ASR-2000 Series User Manual
6
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General
Guideline
CAUTION
 Do not place any heavy object on the ASR-2000.
 Avoid severe impact or rough handling that
leads to damaging the ASR-2000.
 Do not discharge static electricity to the ASR-
2000.
 Use only mating connectors, not bare wires, for
the terminals.
 Do not block the cooling fan opening.
 Do not disassemble the ASR-2000 unless you are
qualified.
 If the equipment is used in a manner not
specified by the manufacturer, the protection
provided by the equipment may be impaired.
(Measurement categories) EN 61010-1:2010 specifies the
measurement categories and their requirements as follows. The
ASR-2000 doesn’t fall under category II, III or IV.
 Measurement category IV is for measurement performed at the
source of low-voltage installation.
 Measurement category III is for measurement performed in the
building installation.
 Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.
 0 is for measurements performed on circuits not directly
connected to Mains.