Manualshelf

User Manual

ManualsBrandsGW Instek ManualsAC Power SourcesAC/DC Power Source, 1kVA, Programmable
151152153154155156157158159160
TEST MODE FUNCTION
151
8. Go to the ON Phs setting and set the starting
phase of the step.
Not applicable for Trans1 and Trans2.
ON Phase
Free, Fixed
ON Phase
0.0 ~ 359.9º
Resolution
0.1º
9. Go to the Fset setting set the frequency of step.
If you input a frequency value that is not
within the range, the warning message below
will be shown.
Not applicable for Trans1, Trans2 and Normal2.
Fset
1.0 ~ 999.9Hz
10. Go to the OFF Phs setting and set the end
phase of the step.
Not applicable for Trans1 and Trans2.
OFF Phase
Free, Fixed
OFF Phase
0.0 ~ 359.9º
Resolution
0.1º
11. Go to the Wave setting and set the wave of step.
Not applicable for Trans1, Trans2 and Normal2.
Wave
SINE
12. Go to the Code setting and set the synchronous
code of the step.
Code
LL, LH, HL, HH