User Manual

TEST MODE FUNCTION
137
13. Go to the Branch 1/2 setting and set a step to
branch to.
Branch 1, 2
ON, OFF, 0 ~ 999
14. Go to the Term setting and set the step
termination setting. CONTI will automatically
go to the next step at the end of the step. END
will return to step 0. HOLD will stay at the
current step until you allow the sequence to
continue to the next step.
Term
CONTI, END, HOLD
15. Go to the Sync Code setting and set the
synchronous code when the step has started.
Sync Code
LL, LH, HL, HH
16. Go to the ON Phs setting and set the starting
phase of the step. The Fixed indicates user-
defined degree.
ON Phase
Free, Fixed
ON Phase
0.0 ~ 359.9º
Resolution
0.1º
17. Go to the OFF Phs setting and set the end
phase of the step. The Fixed indicates user-
defined degree.
OFF Phase
Free, Fixed
OFF Phase
0.0 ~ 359.9º
Resolution
0.1º