User Manual

ASR-2000 Series User Manual
136
DCV
0.0 ~ 500.0V (Range 200V)
0.0 ~ 250.0V (Range 100V)
Secondary
settings
CT (Constant), KP (Keep), SP
(Sweep)
Note: Step 0 can only be set to
either CT or SP.
9. Go to the Fset setting and set the frequency of
the step. If you input a frequency value that is
not within the range, the warning message
below will be shown.
Fset
1.0 ~ 999.9Hz
Secondary
settings
CT (Constant), KP (Keep), SP
(Sweep)
Note: Step 0 can only be set to
either CT or SP.
10. Go to the Wave setting and choose which
waveform to output.
Wave
SIN, SQU, TRI, ARB1 - 16
11. Go to the Jump To setting and choose which
step to jump to, or turn the setting off.
Step
ON, OFF, 0 ~ 999
12. Go to the Jump Cnt setting and set the number
of times the current step will loop.
Jump Cnt
1 ~ 9999, 0
Note: A setting of 0 will set the
number of jump step to be infinite.