User Manual User guide

6 REMOTE INTERFACE
APS-1102A
6-5
3. Press the
ENTER
key to display the selection box.
ENTERCANCEL
4. Press the or key to move the cursor to “INTERFACE”.
ENTERCANCEL
5. Press the
ENTER
key to complete the setting. Press the
CANCEL
key to cancel the setting.
6. Use a D-sub 9-pin cross cable to connect this product to the computer. The connector is on the rear
of APS-1102A.
 Operation steps <2>
Set communication parameter by following steps below.
1. Open SYSTEM MENU to open “REMOTE”.
ENTERCANCEL