User Manual User guide

4 ADVANCED OPERATION EXAMPLE
APS-1102A
4-41
The operation steps are described below.
 Operation steps using control panel
1. Open the PROGRAM screen.
The steps for opening the PROGRAM screen are described in “4.4.2 Sequence
settings”.
 Setting step 1
2. Press the key to move the cursor to “DC VOLT”.
ENTERCANCEL
3. Press the
ENTER
key to display the modification box.
ENTERCANCEL
4. Press the and keys to move the cursor to the 10’s place, then turn the MODIFY dial to set
“2”. Next, move the cursor to the 1’s place and turn the MODIFY dial to set “5”.
 This sets “25.0 V”.
Increase
Decrease
5. Press the
CANCEL
or
ENTER
key to close the modification box.