User Manual Manual

6.3 Command Descriptions
APS-1102 Programmable AC/DC Power Source 6-15
 [SOURce:]CURRent:LIMit:PEAK:HIGH
This sets the upper limit of the output peak current (positive polarity). The output peak current
limiter (positive polarity) setting ranges from 10.0 to 42.0 A (for 100 V range) or from 5.0 to 21.0
A (for 200 V range).
Syntax: [SOURce:]CURRent:LIMit:PEAK:HIGH <NR2>
Parameters: 10.0 to 42.0 (5.0 to 21.0)
Command example: CURR:LIM:PEAK:HIGH 10
Query example: CURR:LIM:PEAK:HIGH?
Response format: <NR2>
Response example: 10.0
 [SOURce:]CURRent:LIMit:PEAK:LOW
This sets the upper limit for output peak current (negative polarity). The output peak current
limiter (negative polarity) setting ranges from 10.0 to 42.0 A (for 100 V range) or from 5.0 to
21.0 A (for 200 V range).
Syntax: [SOURce:]CURRent:LIMit:PEAK:LOW <NR2>
Parameters: 10.0 to 42.0(5.0 to 21.0)
Command example: CURR:LIM:PEAK:LOW 10
Query example: CURR:LIM:PEAK:LOW?
Response format: <NR2>
Response example: 10.0
 [SOURce:]FREQuency[:IMMediate]
This sets the output frequency. When in AC-EXT/AC-SYNC/AC+DC-EXT/AC+DC-SYNC
mode, the frequency cannot be set. ([3, “Invalid in this mode”] error occurs.)
The frequency setting ranges from 1.0 to 550.0 Hz.
Syntax: [SOURce:]FREQuency[:IMMediate] <NR2>
Parameters: 1.0 to 550.0
Command example: FREQ 50
Query example: FREQ?
Response format: <NR2>
Response example: 50.0