User manual

REMOTE INTERFACE
261
OUTPut:TRIGger
Source Specific
Command
Description
Sets or queries the trigger output signal on or off.
By default the signal is disabled. When enabled, a
TTL compatible square wave is output. This
function applies to sweep as well as burst mode.
Syntax OUTPut[1]:TRIGger {OFF|ON}
Parameter OFF Turns the output off.
ON Turns the output on.
Example OUTP1:TRIG ON
Turns the output on.
Query Syntax OUTPut[1]:TRIGger?
Return Parameter
0 Disabled
1 Enabled
Query Example OUTP1:TRIG?
1
The trigger output is enabled.