User manual

REMOTE INTERFACE
253
SOURce[1]:BURSt:STATe
Source Specific
Command
Description
Turns burst mode on or off. By default burst mode
is turned off.
Note
When burst mode is turned on, sweep and any
modulation modes are disabled.
Syntax SOURce[1]:BURSt:STATe {OFF|ON}
Example SOUR1:BURS:STAT OFF
Turns burst mode on.
Query Syntax SOURce[1]:BURSt:STATe?
Return Parameter
0 Disabled
1 Enabled
Example SOUR1:BURS:STAT?
OFF
Burst mode is off.
SOURce[1]:BURSt:MODE
Source Specific
Command
Description
Sets or queries the burst mode as gated or
triggered. The default burst mode is triggered.
Note
The burst count, period, trigger source and any
manual trigger commands are ignored in gated
burst mode.
Syntax SOURce[1]:BURSt:MODE {TRIGgered|GATed}
Example SOUR1:BURS:MODE TRIG
Sets the burst mode to triggered.
Query Syntax SOURce[1]:BURSt:MODE?
Return Parameter
TRIG Triggered mode
GAT Gated mode