User manual

Front & Rear Panel
Front
GND CH1 Output
Power Supply
Status LEDs
CH2 Output
SYNC Output
Positive OutputNegative Output
Power Supply
Status LEDs
Indicates the state of the power
supply (AFG-125P/225P only).
Negative Output
Negative output port.
GND
Ground port
Positive Output
Positive output port
SYNC Ouput
Sync signal output. Outputs a Sync
signal, Sweep marker, Burst
marker,or Arbitrary waveform
marker signal.
CH1 Output
Signal 1 output.
CH2 Output
Signal 2 output.
Front
 MX
 V
INPUT
Vent USB Device Port Input Power
Vent
Cooling vent.
USB Device Port
The USB Device port is used to
supply power as well as
communication from the GDS-2000A
Input Power
A 5V 2A power brick can be used to
power the AFG-225.