User manual

AFG-200 SERIES USER MANUAL
Manual Manual triggering will output a
burst waveform after the trigger
softkey is pressed.
Note
If the APPLy command was used, the source is
automatically set to IMMediate.
The *OPC/*OPC? command/query can be used to
signal the end of the burst.
Syntax SOURce[1|2]:BURSt:TRIGger:SOURce
{IMMediate|MANual}
Example SOUR1:BURS:TRIG:SOUR IMM
Sets the burst trigger source to immediate.
Query Syntax SOURce[1|2]:BURSt:TRIGger:SOURce?
Return Parameter
IMM Immediate
MANual Manual
Example SOUR1:BURS:TRIG:SOUR?
IMM
The burst trigger source is set to immediate.
SOURce[1|2]:BURSt:TRIGger:DELay
Source Specific
Command
Description
The DELay command is used to insert a delay (in
seconds) before a burst is output. The delay starts
after a trigger is received. The default delay is 0
seconds.
Syntax SOURce[1|2]: BURSt:TRIGger:DELay
{<seconds>|MINimum|MAXimum}
Parameter <seconds> 0~655350 nS
Example SOUR1:BURS:TRIG:DEL +1.0000E+01
Sets the trigger delay to 10 seconds.
Query Syntax SOURce[1|2]:BURSt:TRIGger:DELay?
[MINimum|MAXimum]
85