User manual

AFG-200 SERIES USER MANUAL

Burst Mode Commands

Burst Mode Overview

Burst mode can be configured to use an internal trigger (N Cycle

mode). Using N Cycle mode, each time the function generator

receives a trigger, the function generator will output a specified

number of waveform cycles (burst). After the burst, the function

generator will wait for the next trigger before outputting another

burst. N Cycle is the default Burst mode.

*assuming the Trigger polarity is not inverted.

The burst mode depends on the source of the trigger (internal,

manual) and the source of the burst.

Function

Burst Mode & Source N Cycle* Cycle Phase

Triggered – IMMediate, BUS Available Available Available

Triggered - MANual Available Unused Available

Gated pulse - IMMediate Unused Unused Available

*burst count