User manual

AFG-200 SERIES USER MANUAL

SOURce[1|2]:MARKer:FREQuency

Source Specific

Command

Description

Sets or queries the marker frequency. The default

marker frequency is 550 Hz. The marker frequency

is used to output a trigger out signal from the

trigger terminal on the front panel.

Note

The marker frequency must be between the start

and stop frequencies. If the marker frequency is set

to a value that is out of the range, the marker

frequency will be set to the center frequency and a

“settings conflict” error will be generated.

Syntax SOURce[1|2]:MARKer:FREQuency

{<frequency>|MINimum|MAXimum}

Parameter <frequency>

1μHz ~ 25 MHz

1 μHz ~ 1 MHz (Ramp)

Example SOUR1:MARK:FREQ +1.0000E+03

Sets the marker frequency to 1 kHz.

Query Syntax SOURce[1|2]:MARKer:FREQuency? [MINimum|

MAXimum]

Return Parameter

<NR3> Returns the marker

frequency in Hz.

Example SOUR1:MARK:FREQ? MAX

+1.0000E+03

Returns the marker frequency (1 kHz).

SOURce[1|2]:MARKer

Source Specific

Command