User manual

AFG-200 SERIES USER MANUAL
SOURce[1|2]:PM:STATe
Source Specific
Command
Description
Turns PM Modulation on or off. By default PM
modulation is off.
Note
Burst or sweep mode will be disabled if PM
modulation is enabled. As only one modulation is
allowed at any one time, other modulation modes
will be disabled when PM
modulation is enabled.
Syntax SOURce[1|2]:PM:STATe {OFF|ON}
Example SOUR1:PM:STAT ON
Enables PM modulation
Query Syntax SOURce[1|2]:PM:STATe?
Return Parameter
0 Disabled (OFF)
1 Enabled (ON)
Example SOUR1:PM:STAT?
1
PM modulation is currently enabled.
SOURce[1|2]:PM:INTernal:FUNction
Source Specific
Command
Description
Sets the shape of the modulating waveform from
sine, square, triangle, upramp and dnramp. The
default shape is sine.
Note
Square and triangle waveforms have a 50% duty
cycle. Upramp and dnramp have a symmetry to
100% and 0%, respectively. .
Syntax SOURce[1|2]:PM:INTernal:FUNction
{SINusoid|SQUare|TRIangle|UPRamp|DNRamp}
Example SOUR1:PM:INT:FUN SIN
Sets the PM modulating wave shape to sine. .
Query Syntax SOURce[1|2]:PM:INTernal:FUNction?
63