User manual

AFG-200 SERIES USER MANUAL
Phase Modulation (PM)Commands
PM Overview
The following is an overview of the steps required to generate a PM
modulated waveform.
20. Turn on PM modulation using the
SOURce[1|2]: PM:STATe ON command.
21. Use the APPLy command to select a carrier
waveform. Alternatively, the FUNC, FREQ,
AMPl, and DCOffs commands can be used to
create a carrier waveform with a designated
frequency, amplitude and offset.
22. Select an internal or external modulation source
using the SOURce[1|2]:PM:SOUR command.
23. Use the SOURce[1|2]: PM:INT:FUNC
command to select a sine, square, upramp,
dnramp or triangle modulating waveshape. For
internal sources only.
24. Set the modulating frequency using the
SOURce[1|2]:PM:INT:FREQ command. For
internal sources only.
Enable PM
Modulation
Configure Carrier
Select
Modulation
Source
Select Shape
Select
Modulating
Frequency
Set DEViation
25. Use the SOURce[1|2]:PM:DEV command to set
the phase DEViation.
62