User manual

AFG-200 SERIES USER MANUAL
-221 Settings conflict; Coupling can not be performed under current
setting
Example: When sweep mode is enabled,coupling
mode is automatically disabled.
-221 Settings conflict;The dBm units can not used,when load is high_z.
Example: The dBm units can not be used when the
load is high_z.
-221 Settings conflict;value clipped to upper limit.
Example: The parameter was set out of range. The
parameter is automatically set to the maximum
value allowed.
-221 Settings conflict;modulation function can not be performed under
current setting.
Example: A modulated waveform cannot be
generated with the noise or pulse waveforms.
-222 Data out of range;value clipped to lower limit
Example: The parameter was set out of range.The
parameter is automatically set to the minimum value
allowed.
112