Datasheet

PANEL INTRODUCTION
10 11
12
13
14 15
1. TFT LCD Panel
2. Number Panel
3. Scroll Knob & Selection Key
4. Power Switch
5. Output Terminals
6. Main Output Switch
7. Function keys
8. Operation keys
9. USB Host
10. Trigger & Modulation Input
11. Mark & Trigger Output
12. Fan
13. GPIB
14. RS-232
15. USB Device
STANDARD COMMUNICATION INTERFACE
The AFG-3000 provides
GPIB, RS-232, and USB as
standard communication
interfaces. AFG-3000
supports IEEE 488.2
protocol and command
for users to integrate
system or remotely control
the instrument.
1
2 3
4
5
7
8
9
6
4.3" HIGH RESOLUTION LCD DISPLAY
The AFG-3000 is equipped
with a 4.3" LCD screen of
480 x 272 resolution. In
addition to displaying all of
the settings on the screen,
the large graphic display
also allows users to observe
complete waveforms at a
glance.
AFG-3051AFG-3081
Sine, Square, Ramp, Pulse, Noise, DC, Sin(x)/x, Exponential Rise, Exponential Fall, Negative Ramp
Sample Rate
Repetition Rate
Waveform Length
Amplitude Resolution
200 MSa/s
100MHz
1M points
16 bits
Range
Resolution
Accuracy
Amplitude
Offset
Waveform Output
SYNC Output
Sine, Square
80MHz 50MHz
Triangle, Ramp
1MHz
1 Hz
Stability
±℃1 ppm 0 ~ 50
Range
Accuracy
Resolution
Flatness
Units
Range
10 mVpp to 10 Vpp( into 50 ); 20 mVpp to 20 Vpp(open-circuit)Ω
±±1% of setting 1 mVpp (at 1 kHz,>10 mVpp)
0.1 mV or 4 digits
±1%(0.1dB)<10MHz;±2%(0.2dB)10MHz~50MHz;±10%(0.9 dB)50MHz~70MHz;±20%(1.9dB)70MHz~80MHz
(sinewave relative to 1kHz)
Vpp, Vrms, dBm
±Ω5 Vpk ac +dc (into 50 ); ±10Vpk ac +dc (Open circuit)
Accuracy
1% of setting + 2 mV+ 0.5% of amplitude
Impedance
Protection
50 typical (fixed); >10M (output disabled)ΩΩ
Short-circuit protected;overload relay auto-matically disables main output
Level TTL-compatible into>1kΩ
Impedance 50 nominalΩ
Harmonic Distortion
Total Harmonic Distortion
Spurious (non-harmonic)
Phase Noise
-60dBc DC~1MHz,Ampl<3Vpp;-55dBc DC~1MHz,Ampl>3Vpp;-45dBc 1MHz~5MHz,Ampl>3Vpp;-30dBc 5MHz~80MHz,Ampl>3Vpp
<0.2%+0.1mVrms DC ~ 20 kHz
–60dBc DC~1MHz; –50dBc 1MHz~20MHz; –50dBc + 6dBc/octave 1MHz~80MHz
＜＜-65dBc typical 10MHz, 30kHz band; -47dBc typical 80MHz, 30kHz band
Standard Waveform
ARB Function
Non-Volatile Memory
User define Output Section
User define Mark Output
Built in
Ten 1M waveforms
Any section from 2 to 1M points
Any section from 2 to 1M points
Aging
±1 ppm, per 1 year
Tolerance
≤ 1 Hz
m
*1
*2
*5
*5
WAVEFORMS
ARBITRARY
WAVEFORMS
FREQUENCY
CHARACTERISTICS
OUTPUT
CHARACTERISTICS
SINEWAVE
CHARACTERISTICS