Manual

SAFETY INSTRUCTIONS
7
AC Adapter
Power Supply
(AC Mains)
WARNING
 AC Input voltage range: 100VAC-240VAC
 Frequency: 47Hz-63Hz
 Output: 12 DCV, 36W Max
 To avoid electrical shock connect the protective
grounding conductor of the AC power cord to
an earth ground.
Power Supply
(DC)
 DC Input voltage range (10.5-13.5 V DC, 3A)
Cleaning the
Instrument
 Disconnect the power cord before cleaning.
 Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid.
 Do not use chemicals containing harsh material
such as benzene, toluene, xylene, and acetone.
Operation
Environment
 Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)
 Relative Humidity: 20%- 85%
 Altitude: < 2000m
 Temperature: 0°C to 50°C
(Pollution Degree) EN 61010-1:2010 specifies the pollution degrees
and their requirements as follows. The instrument falls under
degree 2.
Pollution refers to “addition of foreign matter, solid, liquid, or
gaseous (ionized gases), that may produce a reduction of dielectric
strength or surface resistivity”.
 Pollution degree 1: No pollution or only dry, non-conductive
pollution occurs. The pollution has no influence.
 Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity caused
by condensation must be expected.
 Pollution degree 3: Conductive pollution occurs, or dry, non-
conductive pollution occurs which becomes conductive due to
condensation which is expected. In such conditions, equipment
is normally protected against exposure to direct sunlight,
precipitation, and full wind pressure, but neither temperature
nor humidity is controlled.