Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
OPERATION
53
Scale
picker
Vertical
Position key
Position
slider
Drag and drop the
Vertical position
key to manually
set vertical
position
Vertical Options – Channel
Background
The Options menu in the Vertical menu allows
you to set the coupling, invert waveforms, turn
the bandwidth limit on, set the expansion mode
and set the probe attenuation.
Setup
1. Select a channel by tapping on the
corresponding channel icon.
Page 51
2. Press the Options icon to bring up the
vertical options.
The vertical options for the selected
channel/waveform will be displayed.
Coupling
1. Press Coupling to set the coupling for the
selected channel.
2. Choose the coupling type in the Coupling
menu that appears.