Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- OPERATION
- REMOTE CONTROL CONFIG
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the measurement or FFT results from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-200 & GDS-300 Series User Manual
160
2. Press the Color Code button for standard pin-
type resistors.
3. Select the 4 band or 5 band tab.
4. Press each of the colored bands in succession
and choose the appropriate color for each band
from the pop-up window.
5. Press Calculate to calculate the value of the
resistor.
Example:
Color Code
Color
bands
Color code button
4 bands 5 bands
Calculate
button
Resistance value
SMD Resistor
Values
1. SMD resistor values can be calculated in one of
3 ways; using a 3 or 4 digit code, using EIA-96
code or using 2%/5%/10% code.
2. Press the SMD button to select SMD resistors.
3. Select the tab corresponding to code used on
the SMD.