Manual
Table Of Contents
- SAFETY INSTRUCTIONS
- GETTING STARTED
- QUICK REFERENCE
- Menu Tree / Operation Shortcuts
- Convention
- Acquire Key
- Acquire Key - Segments
- Autoset Key
- CH1 ~ 4 Key
- Cursor Key
- Display Key
- Help Key
- Math Key
- Measure Key
- Hardcopy Key
- Run/Stop Key
- REF Key
- Save/Recall Key
- Test Key
- Test Key – Go-NoGo
- Trigger Type Menu
- Trigger Edge Menu
- Trigger Delay Menu
- Trigger Pulse Width Menu
- Trigger Video Menu
- Trigger Pulse Runt Menu
- Trigger Rise & Fall Menu
- Trigger Timeout Menu
- Utility Key
- Utility Key – I/O
- Utility Key – File Utilities
- Utility Key – Wave Generator - Demo Outputs
- Search - Edge
- Search – Pulse Width
- Search - Runt
- Search – Rise/Fall Time
- Zoom Key
- Option Key
- Default Settings
- Built-in Help
- Menu Tree / Operation Shortcuts
- MEASUREMENT
- CONFIGURATION
- OPTIONAL SOFTWARE and APPS.
- SAVE/RECALL
- FILE UTILITIES
- HARDCOPY KEY
- REMOTE CONTROL CONFIG
- MAINTENANCE
- FAQ
- I connected the signal but it does not appear on the display.
- I want to remove the (Measurement result / FFT result / Help contents) from the display.
- The waveform does not update (frozen).
- The probe waveform is distorted.
- Autoset does not catch the signal well.
- I can’t save files to the internal memory.
- The display image printout is too dark on the background.
- The date and time settings are not correct.
- The accuracy does not match the specification.
- APPENDIX
- INDEX
GDS-2000A Series User Manual
172
Waveforms
Outputs
Mode
Demo Outputs
Analog
Demo 1
Trigger Output
OR
Pulse Signal:
Burst frequency: 100kHz,
Burst duration: 500uS (50 pulses)
Burst Period: 1mS
Demo 2
FM: 100kHz~1MHz
Demo 3
Probe Compensation output,
1kHz~200kHz, Duty Cycle
5%~95%
UART
Demo 1
Tx: 115200 baud, 8 data bits, no
stop bit
Demo 2
Rx, 115200 baud, 8 data bits, no
stop bit
Demo 3
Probe Compensation output,
1kHz~200kHz, Duty Cycle
5%~95%
I2
C
Demo 1
SCLK, 20kHz
Demo 2
SDA, ID=0x52
Demo 3
Probe Compensation output,
1kHz~200kHz, Duty Cycle
5%~95%
SPI
Demo 1
SCLK, 50kHz
Demo 2
SS
Demo 3
MOSI
Panel Operation/
Parameter
1. Press the Utility key.
Utility
2. Press Demo Output on the lower
menu.