Use and Care Manual

Cleaning & Replacing the Shake-Out Bag
Note: Clean the shake-out bag out-doors when changing the HEPA dust bag. Optimum
performance is achieved by using the HEPA dust bag with the shake-out bag decreasing
the need for washing the shake-out bag.
Cleaning the Shake-Out Bag Used with the HEPA Dust Bag:
1. Remove the shake-out bag, holding the handle at the bottom of the bag, shake out
doors vigorously over a garbage receptacle until there is no
2. Inspect shake-out bag regularly for tears or damage .Replace shake out bags if
damage or tears are present.
Cleaning the Shake-Out Bag when Used Alone (not suggested):
1. Remove the shake-out bag, empty trash can, and shake vigorously out doors until there
is no more dust.
2. The shake-out bag is hand wash-able in lukewarm water.
3. Allow to air dry for 24 hours. The shake-out bag should be replaced when needed
. Never replace into the vacuum if still wet.
Note: If used often without HEPA dust bag, replacement and washing will be required
more often
4. Replace clean shake-out bag in Unit ,and replace the canister lid.
Cleaning the HEPA Pre-Motor Filter
Important, Please Note: The HEPA pre-motor filter will stop most of the tiniest dust
particles and airborne allergens from re-entering the air you breathe. In fact it stops
99.97% of all particles as small as 0.3 microns- many times smaller than a human hair!
Because of this incredible filtration performance, the HEPA pre-motor filter will accumulate
many fine dust particles that are difficult to see. Be assured that the HEPA pre-motor filter
is doing the job. Clean the HEPA pre-motor filter after each use as described in this
section.
1. Remove the shake-out bag from the canister. The HEPA pre-motor filter bag is located
underneath the shake-out bag. To remove the HEPA pre- contents into a motor filter, lift the
form the sides of the HEPA filter.
2. Vigorously ”TapClean” the HEPA pre-motor filter on a hard surface to remove any
residual dust that might still be on the HEPA pre-motor filter.
3. You can wash the HEPA pre-motor filter by running it under the tap and allowing the
water to run on the dirty side when it appears dirty or suction is reduced.