Use and Care Manual

!
Replacing the Drive Belt:
1. Unplug the power cord.
2. Turn the unit over and remove the bottom plate as previously described under
“Replacing Headlight Bulb Step One” on previous page.
3. Lift the rear belt cover up and back.
4. Remove the vented support fitting, noting position.
5. Remove agitator unit and worn out belt.
6. Loop new belt around motor drive shaft and agitator pulley.
7. Reinsert agitator unit into housing, making sure the two ends are positioned in the
support guide.
8. Turn agitator unit by hand to install new belt onto guide, making sure belt is not
twisted and rotating parts move smoothly.
9. Reinsert the vented support fitting and lower rear belt cover.
10.Reinsert bottom plate making certain that the hinges are in place on the front of
the housing before sliding the two latches outward to fasten.
! 17