Use and Care Manual

4. Remove bulb by pushing in lightly and turning counterclockwise.
5. Replace with new bulb, turn clockwise.
6. Reinsert the headlight assembly back into the nozzle housing being careful
not to pinch or re-arrange any wires and insert the two frame screws.
7. Reinsert bottom plate making certain that the hinges are in place on the front
of the housing before sliding the two latches outward to fasten.
Resetting the Thermal Switch:
Model 6000, 7000 , 8000 & 9000
The Thermal Switch protects the motor from overheating. If the motor stops due to
prolonged use, follow steps 1-5.
1. Unplug the power cord.
2. Set power switch on handle to OFF position.
3. Wait about 10 min. to let the motor cool down.
4. Push the reset button lightly to the stop position.
5. Restart your vacuum cleaner.
Replacing the fuse:
Model 6000, 7000, 8000 & 9000
The fuse protects the motor from overload. If the motor stops due to prolonged use,
check fuse follow steps 1-5
1. Unplug the power cord.
2. Open the motor cover.
3. Push and turn the fuse holder counterclockwise to open it. ant remove the fuse.
4. Install the new fuse, push and turn the fuse holder clockwise to close it.
5. Reinstall the motor cover.
! 16