Use and Care Manual

of the switch cover below the easy carry handle will activate when the dust bag is full,
or if the vacuum cleaner is clogged. Replace bag if full.
To check for clogs, unplug vacuum cleaner and inspect agitator area (see “Removing
the bottom plate” on page 17) hose and attachment inlet.
Special note: when cleaning with attachments, disregard the full bag indicator light.
Normal airflow restrictions occur with attachment cleaning and may trigger a false
signal.
When turning on the vacuum cleaner while the full bag indicator light is on and the
vacuum cleaner will not start, check to see if the dust bag is installed correctly.
Handle Adjustments:
The handle of this vacuum cleaner can be set to any of three positions: upright,
middle, or low. To release the handle, step on the pedal at the left rear corner of the
vacuum cleaner.
1. Upright position: handle locks in this position for vacuum cleaner storage. The
handle should always be in the upright position when cleaning tools are used.
2. Middle position: this position is for normal cleaning. While in the middle
position, the front of the nozzle can be raised by lowering the handle in order
to cross room thresholds.
3. Low position: this position is used for cleaning under most furniture.
! 11