Use and Care Manual

motor from dust and dirt. Operating the vacuum without the secondary filter in
place voids the warranty.
1. Check for accumulated dust and dirt when replacing dust bag.
Filter may be cleaned as needed.
2. If replacement is needed, release the right tab
on underside of bag supporter. Lift and rotate
bag supporter to remove.
3. Remove secondary filter from bottom of dust
compartment.
4. Replace secondary filter with new filter.
5. Reinstall bag supporter.
Checking the Post Filter:
The auxiliary post filter captures fine dust particles
and purifies air exiting your vacuum cleaner.
Change or clean the post filter with every third dust bag replacement, or as
needed.
1. Depress handle release pedal to drop vacuum cleaner to low position.
2. Push knob at side of post filter to remove post filter cover.
3. Remove soiled filter and replace with new one. (Do not wash.)
Special Features Make Your Vacuum a Peak Performer!
ON/OFF Switch:
Model 6000 & 8000 Vacuum Cleaners have a simple
toggle switch on the dust compartment. Push down ---
to start. Push down O to stop.
Model 7000 & 9000 are equipped with a convenient
handle slide switch to turn power ON and OFF.
Automatic Self-Adjusting Carpet Nozzle:
Your vacuum can float evenly over varying carpet pile lengths. The carpet nozzle
raises itself instantly and automatically.
Full Bag
Indicator
Light:
Model 7000 & 9000
A warning light located on the front
! 10