Use and Care Manual

PROPER STORAGE

When the vacuum is not in use, it should be stored in a dry place

ELECTRICAL CORD CARE

NEVER stretch the cord tightly between the vacuum and the outlet. A cord that is stretched or pulled will not

function properly and creates a danger.

After vacuuming, unplug the cord and wind it up loosely . DO NOT wind the cord up by wrapping it around your

hand and elbow.

CARING FOR YOUR VACUUM

1. Every time you finish vacuuming, shake out the cloth and Paper dust bags (No.31 and No.32).

2. Each week, rinse, dry and return the foam (NO.21) at the bottom of the appliance below the motor.

3. After each shift, wipe the inside and outside of the vacuum with a household cleaning agent.

FILTER MAITENANCE

1. Check the paper dust bag (No.32) each time you start and finish vacuuming. A clogged and dirty dust bag

restricts airflow and results in reduced suction and overheating.

2. While vacuuming throughout a building, stop every two hours or as needed to

shake out the paper dust bag (No.32). Replace the paper dust bag when

necessary. (Figure J)

NOTE: Lift both paper dust bag and cloth bag out at the same time to avoid

ripping the paper dust bag, especially it is full.

3. Once a month (or as needed) hand or machine wash the cloth dust bag (No.31)

and let it LINE DRY. (Do not put it in the dryer).

4. Once a month (or as needed) clean the HEPA filter (No.2) between the motor

guards, located inside the vacuum under the paper and cloth dust bag.

(Figure K)

a. Pull the top piece of the motor guard (No.1) off and remove the

HEPA Filter (No2). Shake it out, rinse it and let it air dry

thoroughly. Gently using compressed air can be used for a dry

clean.

b. Before the next use, return the HEPA Filter (No.2) to its place.

Replace with new foam media if necessary.

c. Firmly snap the top piece of the motor guard (No.1) into place.

5. As needed rinse, air dry, and return the foam filter (No.22) at the bottom of the appliance below the motor

a. Pull out the round rubber support (No.21)and take foam filter(No.22) out, rinse it and let it air dry

thoroughly.

b. Before the next use, return the foam filter (No.22) to its place.