User Manual
STREAM USERS MANUAL
PAGE 8
OPERATION – PRESSURIZED WATER FROM FAUCET
1) Thread hose fitting (3/4” GHT) on red intake hose on to pressure regulator. Failure to use
pressure regulator may lead to flow rates that are too high for adequate disinfection.
2) Thread PRESSURE REGULATOR onto water faucet.
3) Press power button to start flow of water. On initial set up it may take up to 60 seconds for air to purge
from system.
NOTE: Pump will not run when operating in pressurized water mode. Reduced power requirements
will extend battery life.
4) Press power button again to stop the flow of water.
POWER BUTTON