User Manual

STREAM USERS MANUAL
PAGE 13
WATER MUST BE REMOVED FROM STREAM TO PREVENT DAMAGE FROM ICE EXPANSION.
1) Follow inital set up instructions to install inlet and outlet hoses. Allow inlet hose to ingest air. (Do
not submerge or connect inlet hose to water source.) DO NOT install PRESSURE REGULATOR or
PREFILTER to inlet hose.
2) Open lid.
3) Push power button to turn on STREAM. Pump should run. Observe water drain out of carbon
block filter housing. Run Stream for 30 seconds. Push power button again to turn OFF power.
4) Invert and hold the STREAM with the lid facing down. Unscrew the carbon block filter housing and
remove the carbon block filter cartridge. Find the o-ring housing seal. Set aside and allow to dry.
5) Reinstall carbon block filter housing, ensuring o-ring seal is seated in groove. Place STREAM with
the lid side up.
6) Push power button to turn on STREAM. Pump should run.
7) As the pump continues to run, observe remaining water is coming out of STREAM. Continue for
60 seconds or until no water comes out outlet hose. Change orientation of STREAM to place handle
up. Run for up to 60 seconds to pump remaining water out of STREAM. Continue for 60 seconds or
until no water comes out outlet hose.
8) Disconnect hoses, drain water from them. Store carbon block cartridge separate from STREAM.
9) For long term storage, allow hoses, carbon block filter cartidge, and the interior of STREAM CASE
to thoroughly dry.
STREAM MAY BE DAMAGED BY FREEZING
TEMPERATURES DUE TO ICE EXPANSION
FREEZING TEMPERATURE / LONG TERM STORAGE PREP