Installation Guide

For creating an end cap, trim o a few
inches from the front and back rail. You
will need to expose enough mesh to
cover the gap at the end of the gutter.
Push the mesh into the gutter end to
seal the space.
INSTALLATION
If taping it on, peel back the rst
couple inches of the red protective
layer on the adhesive foam tape.
Place the gutter guard and press the
top down rmly to seal.
TAPE INSTRUCTIONS
If screwing it down, use the guides
on the front rail to place the screw.
Fasten with 3 screws for each
section of gutter guard.
SCREW INSTRUCTIONS
For joining sections together- lay one
end of the mesh so it overlaps directly
over the other section.
FOR JOINING SECTIONS
FOR MAKING THE END CAP
Refer to pages 11-12 for
installing at an inside and/or
outside corner.
FOR CORNERS
OR
8
6
7
5
9
9