Instructions / Assembly

5
Pull red strip off.
Slide section under roof shingle.
Push down firmly by sliding finger along top.
Step 2.1
Clean: Wipe off top of gutter so it’s very clean by using a mixture of
rubbing alcohol and water. Wipe off all residues.
Step 2.2
Straight Sections: Peel off a few
inches of the red strip.
Mesh extends slightly past the ends of each section. Line the ends up and the mesh will overlap each other. Just set the mesh
ends on top of each other (A). It is ok to have gaps between the sections like on (B) above. The mesh is recessed in the gutter
slightly so rainwater will not run off (B). If the mesh is bowed up at the point where both sections join, where leaves can come
through, you can bend the mesh flat to close the gap, or you can put a screw through both pieces of mesh to close the gap. If you
want more screws for this, just email me at [e-mail] and my team will ship you more at no charge.
Step 2.3
Joining sections
B
A