Manualshelf

Use and Care Manual

ManualsBrandsGutter Guard by Gutterglove ManualsBuilding materials3 ft. L x 5 in. W Stainless Steel Micro-Mesh Gutter Guard (13-Pack)
12345678910
INSIDE MITER
Trim off aluminum ends, exposing mesh. Tuck mesh down inside gutter adjacent to adjoining miter.
OUTSIDE MITER
Bend one section down in gutter to allow room for adjoining section. Cut adjoining section at 45 degrees.
END CAP
Trim off aluminum ends and then tuck mesh inside gutter.
7
Install Basics
CUTTING SECTIONS
Trim off the tip of the mesh that extends past the edge of the
front rail. Overlap sections together on top of each other.
Cut front & back aluminum rail. Trim mesh. Snap in two.
JOINING SECTIONS