Use and Care Manual

IMPORTANT Install Reminders:
Prior to installing gutter guards, ensure you clean out your gutters by clearing them of all
leaves, pine needles and other debris including your downspouts.
Also, complete any repairs to your gutters and downspouts as needed.
If your roofing material is adhered to your underlayment, do not pry up your shingles or
tear your underlayment. Use one of the bending methods shown on Pages 4 and 5
instead.
When installing gutter guards, make sure to obey local building codes.
Choose Install Option: Tape It On or Screw It On
2 Install Options:
You can either Tape it on with the 3M Very High Bond tape that comes on each section of
gutter guard, or you can Screw it on with the supplied self-tapping screws (use 3 screws
per 4 foot section).
TAPE IT ON: Ensure you clean off the front top lip of your gutter by using a mixture of
rubbing alcohol and water, and wipe off all residue. For best results, install in 65-degree
weather or warmer. Allow a minimum of 12 hours to cure for full bond.
SCREW IT ON: Use 3 self-tapping screws per 4 foot section. The supplied screws self-drill
a hole while being screwed through the front edge of the gutter guard into the front lip of the
gutter. A magnetic Hex Head Driver Bit is also included. If you need additional screws for
your installation, please contact [e-mail] or call 866-892-8442.
Tape it on
Use 3 screws per
4 foot section
Screw it on
Support
866-892-8442
[e-mail]
2