Installation Guide
PRE-INSTALL
CHOOSE YOUR
SECURING METHOD
PRE-INSTALL
4
We’ve designed Gutter Guard by Gutterglove
®
with a simple
installation in mind. Manageable sections slide right into place. Then,
either tape them on with the 3M high-bond tape, or screw them on.
Most homes are completed in an afternoon.
SECURING
TAPE IT ON
❏ Clean o front lip of gutter with acetone.
❏ Install in 65º weather or warmer.
❏ Allow 12 hours to cure for full bond.
SCREW IT ON
❏ Use 3 self-tapping screws per section.
❏ Pre- drilling not required.
REMOVE THE GAP THE TROUGH
Front frame of the gutter guard should be
at against the front lip of your gutter.
The trough (see page 2) should be at
least 1/8” below the lip of the gutter. This
adjustment may need to be made on steeply
pitched roofs or gutters that are hung 1 inch
or lower below the rooine.
Push down rmly with your ngers
Front lip
of gutter
Rainwater may run over the front lip of your gutter if these steps are overlooked.
IMPORTANT: DON’T MISS THESE STEPS!
PUSH DOWN FLAT
TO REMOVE GAP.
INCORRECT
7