Installation Guide

GUTTER
FASCIA
WOOD
METHOD
METHOD C
STEEP ROOF
INSTALLATION
Slide it under the roof shingle, if it
causes the roof shingle to ramp up
or your roong material is adhered
to your underlayment, see Method
B and bend the mesh up or down
and fasten to the gutter, drip edge
or fascia with screws. (See page 13)
METHOD D
ALTERNATIVE INSTALLATION
METHOD
If the gutter guard isn’t wide enough
to slide under the roof shingles, put
3 screws in the back of the gutter,
drip edge or fascia to hold up each
section of the gutter guard, then use
the tape method to secure the gutter
guard to the front lip of the gutter.
GUTTER
GU
TT
ER
GU
AR
D
ROOF
SH
I
N
GL
E
FASCIA
WOOD
ROOF
SH
I
N
GL
E
BEND
BEND
METHOD
UP
DOWN
PRE-INSTALL
The gutter guard should be bent down at
an angle to slide under the shingle without
ramping up.
The gutter guard is installed improperly
since the shingle on the roof is being
impacted.
Roof Shingle
Ramped Shingle
Correctly-Installed
Gutter Guard
Incorrectly-Installed
Gutter Guard
Gutter
INCORRECT
Gutter
IMPORTANT NOTE FOR ALL INSTALL METHODS
AVOID ROOF RAMPING
X
CORRECT
INSTALL METHODS CONTINUED
GU
TT
ER
GU
AR
D
6