Installation Guide

gutterguard.com/contact | [phone] | M-F 8am-7pm CST
NEED HELP?
Bending the mesh allows you
to t the gutter guard on any
gutter-to-roof scenario.
MEASURE & MARK
Once you have all materials
gathered, measure and mark
where the bend needs to be
on the mesh based on your
gutter-to-roof scenario.
CLAMP MESH
Clamp the gutter guard
between two 1”x2” boards
to hold it in place.
BEND MESH
Use the leverage from the
clamp and/or boards to
bend the mesh along the line
you’ve marked.
Note: Bend the mesh either up or
down depending on the type of
roof you have.
INSTALL
Making sure the mesh is bent
at an angle that aligns with
your roof conguration, install
the gutter guard per the best
installation for your gutter-to-
roof scenario. (See pages 5-6.)
1
2
3
4
BENDING THE MESH
gutterguard.com/contact | [phone] | M-F 8am-7pm CST
NEED HELP?
What you’ll need:
❏ Two - 1”x2” boards that are 4.5’
long with square edges
❏ Two - 4” clamps
❏ Measuring Tape
❏ Permanent Marker
❏ Gloves
INSTALLATION
Bending The Mesh
DO IT RIGHT. DO IT ONCE.
13