Installation Guide

INSTALLATION
Let the piece run long to the end of the gutter. Bend down the back
aluminum rail into the gutter. Mark the adjoining piece at the same
angle as the roof edge, then use tin snips to cut away the outlined
piece. Once cut, t it into the outside edge so that it’s aligned with
the opposite piece.
1
1
3
3
2
2
4
4
OUTSIDE CORNERS
Trim back the aluminum rails and tuck the exposed mesh down into
the gutter. Make sure the entire gutter end is sealed.
END CAPS
End Caps & Outside Corners
DO IT RIGHT. DO IT ONCE.
12