Installation Guide

INSTALLATION

Decide how you will fasten your gutter

guards, tape or screws. If you use the tape

option, make sure to clean the top front lip

of the gutter using acetone.

FOLLOW ALL PRE-INSTALL STEPS

We recommend starting at an inside

corner. If you do not have one, start by the

downspout. Otherwise, start and the end of

the gutter.

STARTING OUT

Use a new, or freshly sharpened, pair of tin

snips for cutting the aluminum rail. A pair

of commercial grade scissors will work for

cutting the mesh.

Depending on the install method you chose on

pages 5-6, you may need to bend the mesh up

or down to achieve the recommended slope of

the gutter guard (5º-25º). See page 13 for further

instruction on how to bend the mesh.

If you chose method A, you can skip this step.

FOR CUTTING SECTIONS

DID YOU CHOOSE METHOD B OR C?

BENDING THE MESH (If Necessary)

TYPICAL

INSTALLATION

This section provides general guidance on getting started and working your way

through an install. Remember to check pages 4 – 6 to determine the installation

method that will work best with your gutter-to-roof scenario.