User's Manual
17 I 19
10 Detailed Instructions of Kit Setup
For the Correlation Operation:
Connect the clip to the sensor:
1. Push clip vertically over the top of
the sensor handle
2. Push the clip down until you hear
a second click
3. Pull the clip back up until the
sensor handle is blocked in the clip
hooks (and you hear a click)
Release the sensor from the clip:
1. Push the clip down to release the
sensor handle from the hooks
2. Turn the clip carefully sideways
on the handle
3. Release the clop by pushing the
hooks over the handle edge
For the Ground Microphone Operation:
1. Screw the handle rod into the
extension rod
2. Screw the extension rod into the
ground plate
3. Place the sensor with magnet
onto the ground plate (centered)
For the Listening Stick Operation:
1. Screw the pointed rod into the
extention rod
2. Screw the extension rod into the
sensor as shown
3. Screw the rods tightly to improve
stability