User's Manual

44 I 72
Figure 49: Entering Data Pipe
• In the Manual Pipe Setup window click Add Segment to enter the
Length, Material and Diameter. When all segments are entered
click Save
Figure 50: Manual Pipe Setup
• There is also a Pipe Wizard available, refer to 3.2.3 Entering Pipe
Data with Pipe Wizard
Once the Pipe Setup and Filtering is complete the Manual Correlation
Dashboard window will look similar to the screen below. In this
example a 70% correlation was achieved and the leak position is
depicted by an orange dot on the map and the diagram between the
cross correlation graph and the map.
• Use the signal spectrum as a guide to position the filters, in the
example below there is a concentration of sound between 300 and
400 Hz so this must be included