Safety Guide

13 I 13
8 Conformity
This radio transmitter IC: 9789A-HISCAN915V1 has been approved by Innovation, Science
and Economic Development Canada to operate with the antenna types listed below, with the
maximum permissible gain indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are strictly prohibited for use with
this device.
Le présent émetteur radio IC: 9789A-HISCAN915V1 a été approuvé par Innovation,
Sciences et Développement économique Canada pour fonctionner avec les types d'antenne
énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus
dans cette liste, et dont le gain est supérieur au gain maximal indiqué pour tout type figurant
sur la liste, sont strictement interdits pour l'exploitation de l'émetteur.
Antenna Info: GT-ANT01 / -0.4 dBi / 50 Ohm
This device complies with part 15 of the FCC Rules and contains licence-exempt
transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux
CNR d’Innovation, Sciences et Développement économique Canada applicables aux
appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions
suivantes :
1. L’appareil ne doit pas produire de brouillage;
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
9 Important Information
Please draw your attention to all warnings and information in the manual and on the products.
By using this product, you acknowledge that you are aware of and have read the warnings and
information provided in the manual.
Always clean the sensors and mechanical accessories with a clean towel after use
before stowing them away in the carry case.