User's Manual
Step 1: Open the unit by using either your backup keys
or current access code and locate the Learn button which
can be found on the interior panel of the unit.
Step 2: Use steps 3-7 in the Programming Digital
Keypad section to change your current combination.
Step 3: Now you have successfully reprogrammed your
safe.
Entering an invalid access codes triggers the Tamper
Detection feature.
Resetting Passcode
For Digital Keypad
Tamper Detection
Step 1: Press and hold down buttons ‘2’ and ‘3’ for
ve seconds to initiate the Tamper Detection indicator.
Step 2 : If tampering has been detected the indicator
light will remain red until buttons ‘2’ and ‘3’ are released.
Step 3: If tampering was not detected the indicator
light will remain green until buttons ‘2’ and ‘3’ are
released.
05
Safety Features For Digital Units
Step 6: Enter your new access code a second time. During
this step the red indicator light will remain illuminated.
Step 7: Press and hold the Learn button a third time.
The indicator light will ash green and beep six times
this will conrm that the new code has been accepted.
If the indicator light illuminates in red and beeps six
times an error has occurred and you will need to repeat
steps 3-7.
Step 8: Test your combination to conrm that your
unit has accepted your new access code.
Step 9: Now you are ready to use your safe.
Low Battery
Warning Indicator
Step 1: When your unit has low battery the unit
indicator light will ash red and beep six times. Depen-
ding on how low the battery is the unit may sound when
releasing the lock. If the battery is too low the indicator
light will start ashing red and beep continuously until
battery is removed from the unit. If the battery is
completely depleted you will only hear a light humming
sound.
Step 2: Replace battery by using steps in section
labeled Battery Installation.
*The low battery indicator only goes off when you are
in the process of opening your unit.
Interior Courtesy Light
•
The interior courtesy light activates for ve seconds
when the safe door is opened. The light will illuminate
the contents of your safe making it easier to access even in
the dark.
Security Sleep Mode
• After six incorrect entries the Security Sleep Mode
feature will be triggered and will lockout any new
keypad entries for two minutes. When Security Sleep
Mode is active and a button is pressed the indicator
will ash red and beep three times.
•
To verify that the Security Sleep Mode is deactivated
wait two minutes and then test your unit by slowly typing
in your combination. If the indicator ashes green your
Audio Control
This feature turns audio for unit on and off.
Step 1:
Open the unit and locate the Mute button on the
interior panel of the unit.
Step 2 :
Press and hold the Mute button for three seconds.
While holding the mute button the indicator light will
remain solid red. When the indicator light ashes green
and beeps three times you have successfully activated/
deactivated the audio control feature.
combination has been accepted and the unit will open. If
the indicator ashes red your combination is incorrect
and you will need to try again. If you have forgotten or
lost your combination please follow the instructions on
Programming Digital Keypad. Your backup key will be
required if reprogramming is needed.